Getting the head prepared for glass particle blasting.
I made this little clutch holding tool, after searching the internet for solutions to get the clutch out of the engine. Not exactly happy with it. I should have used some more of those metal plates. The single one has left
As I mentioned before I bought two bikes to start with. So I got two XS750 engines to choose from. One of them wasn’t running for more then a decade and the other one was pretty much at the end
Finalizing the lines of the fuel tank and the seat. Way more work then I expected it to be. Now, the base plate of the seat needs a bit more stiffness and under the seat will be a compartment for all
Finally I got a rolling chassis. Almost like a motorcycle – just without engine!
finally I finished the wheels and almost the fork. New bearings and seals in both rims. Cause I don’t own the fancy tool for that I used a punch and a hammer for both – getting the old bearings out of
After hammering for an hour (at least it felt like that) the bearings for front wheel are in. I always start way to gently when doing things like that…
The freshly honed cylinder is back as well. Now it got to sit around and wait for a while. Would like to focus on the fork and wheels now, in order to have a rolling chassis soon.
This morning I picked up the rims and parts of the fork from the powder coater. I’m quite pleased with the result! Now there is more then enough work waiting for me. Once the fork is assembled and the rubber