Concorso d’eleganza 2017
A few pics of this year’s concorso d’eleganza at villa Erba in Cernobbio, italy.
time laps – rejetting the carbs
Carbs
In the meantime I started with the carbs. From the outside they looked unbelievable bad. Some previous owner decided to paint the engine, including the carbs black with a spray can. All still mounted in the frame I guess. But
luckily I bought two bikes
Did not see any cracks when sanding and painting it. When tightening the screw it fell apart..
the last engine parts now in a friendly black
fuel taps xs 750 – the second …
Small update on the fuel taps. I ordered a piece of gasket paper and made all new gaskets for the converted fuel taps. Before I did this, I plane grinded all the pieces, except the lower part, where the fuel
a few more steps
Did a few more steps the last days. Finally I put the cylinder head back on the engine. Procrastinated quite a bit with that. I was not sure if I took care of the orientation of the piston rings, so
fuel taps rebuild
Because one of my fuel taps is leaking, I’m trying to convert them to manual ones. In the hope they will work reliable in the future. Here I found a very good step by step instruction, I followed so far.
Control unit for the bike electrics using arduino and relays
This is an other side project for my bike build. For the clean and tidy appearance of the bike I’d like to use minimalistic switches on the handle bar. And to use them I need a control unit, that does
foot pegs
After some more testing I am now very sure: the Raask rearset is the way to go. It still feels a little too far back and also somewhat high, but it still feels so much better then the foot pegs in